KatsBits Community

Chose a 0 valued axis

kat · 1 · 10648

0 Members and 1 Guest are viewing this topic.

Offline kat

  • Administrator
  • Hero Member
  • *
    • Posts: 2708
    • KatsBits
Problem
What does this mean...

Code: [Select]
************ ERROR ************
Chose a 0 valued axis

Solution
This error occurs when you try to cap a cone. The problem is that the top of the cone get's a 0x0 cap. So... remove the top (read 'small') cap of that cone [Hr.O]



[Addendum] The nature of the problem means the patch mesh 'cap' is tiny, essentially just co-located vertex points, making selection difficult. In such instances draw out a brush volume large enough to cover the top of the cone and click "Select Inside". The infinitely small mesh cap should self-select for deletion. [kat]