KatsBits Community

Game Editing => General Content Creation => Topic started by: yeedoo on December 04, 2010, 01:31:34 PM

Title: [CoD4] how to cut/clip a patch surface?
Post by: yeedoo on December 04, 2010, 01:31:34 PM

hi kat!
Like the clipper tools works with the brush. How to make a hole on the patch surface? Like this (shown in CoD4 Radiant) http://www.screencast.com/t/3uHjkVb2fET

Title: Re: [COD4Radiant]how to clip a patch surface?
Post by: kat on December 04, 2010, 05:49:04 PM

Are you trying to put a window (hole) in that curve? Yeah you can't do that to patches so you have to work around the problem. Give me a few and I'll see if I can knock some screenshots up for you.

Title: Re: [COD4Radiant]how to clip a patch surface?
Post by: yeedoo on December 05, 2010, 02:23:29 PM

I see, I don't have to make a hole to fit a window on patch, just use texture, break the patch into three parts, in one of which put a window texture. See the following screenshots, both from CoD Radiant.

http://www.screencast.com/t/zJaCU1f8
http://www.screencast.com/t/nlRmhgRJn

But I must make the outer window and inner window respectively